Search results
1976
[Page extract]
Speak to an Expert
The Concora Crush Test, as defined in TAPPI T 824, is a critical step in corrugated medium evaluation.
1977
[Page extract]
Equipment and procedures
SCT testing equipment and tools
Accurate SCT testing requires equipment that can apply controlled and repeatable loads:
1978
[Page extract]
Speak to an Expert
Compressive shear testing is essential for verifying adhesive bond strength, layered composite integrity, and internal shear resistance in structural materials.
1979
[Page extract]
Cord, rope and netting
Cord, rope and netting all rely on their inherent strength to perform the essential tasks of tying, lifting and dragging.
1980
[Page extract]
Key test standards
Grab method testing is governed by several internationally recognised standards, including:
1981
[Page extract]
Loop tack test standards
Several international standards govern loop tack testing to ensure results are consistent and repeatable:
1982
[Page extract]
Introduction to edge crush testing (ECT)
The edge crush test (ECT) is a standard method used to evaluate the edgewise compressive strength of corrugated fibreboard.
1983
[Page extract]
Key methods in shear stress measurement
There are several approaches to measuring shear stress, with rotational shear testing and torsion-based techniques among the most widely used.
1984
[Page extract]
Equipment and techniques
Accurate T-peel testing requires precise, calibrated instruments.
1985
[Page extract]
Introduction to torque testing
Torque testing is a vital part of packaging quality control.
1986
[Page extract]
Applications of bursting strength testing
Ball burst testing is routinely used across sectors where material failure under localised stress poses a risk to performance or safety. Common application areas include:
1987
[Page extract]
Interpreting results and ensuring accuracy
Accurate results rely on correct setup and consistent procedures:
1988
[Page extract]
Case studies - real-world applications
Medical vial stoppers
A pharmaceutical company tested rubber vial stoppers to ASTM F2132 to ensure they resisted accidental puncture during handling.
1989
[Page extract]
Applications of short span compression testing
SCT is widely applied in quality assurance, R&D, and material qualification:
1990
[Page extract]
Standards and compliance
Commonly referenced standards for tangent modulus testing include:
1991
[Page extract]
ECT vs BCT
While ECT measures the compressive strength of the board material, the box compression test (BCT) measures the strength
1992
[Page extract]
Adapting to new materials
As new materials such as bio-based films, nanocomposites, and high-performance fibres emerge, testing methods must adapt.
1993
[Page extract]
FAQs
Find answers to common questions about syringe testing and ISO 11040-4:
1994
[Page extract]
What is Ultimate Tensile Strength in Materials Testing?
Ultimate tensile strength (UTS) refers to the maximum stress a material can endure while being stretched before it fails.
1995
[Page extract]
Comparative analysis of testing standards
Different standards address specific materials and applications:
1996
[Page extract]
VectorPro's key features
Design
Intuitive icon-driven interface and workspace
Advanced 'drag and drop' test routine builder
Personalised u
1997
[Page extract]
Step-by-step guide to conducting a CMT test
Prepare the specimen - Cut to size with clean edges, ensuring flutes remain undamaged, and condition as per the standard.
Calibrate the equipment - Check the load cell and platen alignment.
1998
[Page extract]
What is the trapezoidal tear test?
The trapezoidal tear test is a mechanical method used to determine the tear strength of flexible sheet materials.
1999
[Page extract]
Applications in industry
The Delft tear test is used wherever rubber and thermoplastics need to maintain performance under stress. Common uses include:
2000
[Page extract]
Speak to an expert
If you require loop tack testing to meet quality, performance, or compliance requirements, Mecmesin can provide the right solution for your application.