Online demonstrations and training available from Mecmesin technical sales engineers

Online test equipment and training demos


As more people are working from home to reduce travel, our technical sales engineers can provide online equipment demos or training sessions via web-based video calls.

If possible, send in your own samples and our sales team will be able to present your own products being tested.

Get in touch to discuss your requirements and to arrange an online demo or training session.

Helical torsion spring torque testing

10 October 2018


  • Any of Mecmesin's software-controlled torque testers
  • EmperorTM rotates the spring to a predefined angle, continuously collecting torque and angular displacement data.


  • To measurement of the stiffness, or spring rate, to ensure correct design specification.
  • Ulimate repeatability with software control and custom fixtures matched to the spring samples


Spring-loaded components are used extensively in home and consumer goods: clothes pegs, clips and old-fashioned mousetraps; small doors and flaps on cameras or hi-fi equipment; large doors and closures such as those on garages or gates and in transport applications like vehicle luggage compartments. 

Despite being termed ‘torsion’, and operating under torque loading, the spring itself is subjected to a bending stress when the ends rotate about its central axis, driven by the components attached to either arm (or leg).

The parts of an assembly, which are required to rotate in service, depend greatly upon the spring’s stiffness rating.

This determines if the assembly is fit for purpose and exhibits the correct level of resistance for ease of operation and quality feel.


A motor-driven test stand controlled by software rotates the spring to a pre-defined angle and collects the torque and angular displacement data continuously.

The software ensures repeatable testing in clockwise or anti-clockwise directions and protects against permanent set in the spring material.

Approaching the target load point from below and above, then averaging, minimises the effect of friction and hysteresis on the results caused by the contact between the spring coils.

The requirement to lie within specific torque range limits - when rotating the spring within its linear, elastic region - is immediately visible to operators through a clear PASS/FAIL indication.

In the smallest of torsion springs, used in precision applications, the frictional forces experienced by the coils may be highly significant.

The need is greatest to employ a test system which not only ensures that the spring’s axis remains aligned to within tight tolerances, but accurately measures the resulting very light torque values. 

Test equipment

  • Vortex or Helixa torque testing system with appropriately rated sensor.
  • EmperorTM fully programmable torque testing software.
  • Custom-designed cores and mandrels matched to the helical geometry.
Talk to your Mecmesin representative in your country for solutions, pricing and support

Got a question about this system? Get in touch and speak to one of our Technical Sales Engineers now...

Speak to an expert